Nodes of different colours represent the following:
Solid arrows point from a procedure to one which it calls. Dashed
arrows point from an interface to procedures which implement that interface.
This could include the module procedures in a generic interface or the
implementation in a submodule of an interface in a parent module.
Where possible, edges connecting nodes are
given different colours to make them easier to distinguish in
large graphs.
Nodes of different colours represent the following:
Solid arrows point from a procedure to one which it calls. Dashed
arrows point from an interface to procedures which implement that interface.
This could include the module procedures in a generic interface or the
implementation in a submodule of an interface in a parent module.
Where possible, edges connecting nodes are
given different colours to make them easier to distinguish in
large graphs.
Source Code
subroutine continuity_enter_data_impl(this)type(continuity_t),intent(inout)::thiscall scratch_3d_buffer_enter_data_impl(this%h_face_left_x)call scratch_3d_buffer_enter_data_impl(this%h_face_right_x)call scratch_3d_buffer_enter_data_impl(this%h_face_left_y)call scratch_3d_buffer_enter_data_impl(this%h_face_right_y)call scratch_3d_buffer_enter_data_impl(this%mt_h_new)call scratch_3d_buffer_enter_data_impl(this%mt_grounded)call scratch_3d_buffer_enter_data_impl(this%pd_theta)! Phase 2 flux accumulators (allocated-but-unused at ratio=1; the! windowed drain in Phase 6b reads/writes them on the device).if(allocated(this%uhtr))then!$acc enter data copyin(this%uhtr, this%vhtr)end if! Phase 2 (6b) windowed-drain workspace.if(allocated(this%hprev_work))then!$acc enter data copyin(this%h_win_start)!$acc enter data copyin(this%hprev_work, this%uhr_x, this%uhr_y, &!$acc this%uhh_x, this%uhh_y, this%tr_flux_x, &!$acc this%tr_flux_y, this%tr_work, this%pal, &!$acc this%par, this%pa6)end if end subroutine continuity_enter_data_impl