Nodes of different colours represent the following:
Solid arrows point from a procedure to one which it calls. Dashed
arrows point from an interface to procedures which implement that interface.
This could include the module procedures in a generic interface or the
implementation in a submodule of an interface in a parent module.
Where possible, edges connecting nodes are
given different colours to make them easier to distinguish in
large graphs.
Nodes of different colours represent the following:
Solid arrows point from a procedure to one which it calls. Dashed
arrows point from an interface to procedures which implement that interface.
This could include the module procedures in a generic interface or the
implementation in a submodule of an interface in a parent module.
Where possible, edges connecting nodes are
given different colours to make them easier to distinguish in
large graphs.
subroutine register_ocean_geothermal(cfg,schema)!! `&ocean_geothermal_nml`: geothermal bottom-heat-flux switch +!! scalar flux. Bed-side analogue of the surface heat flux.type(config_t),target,intent(in)::cfgtype(nml_schema_t),intent(inout)::schematype(nml_group_t)::glogical,pointer::plreal(wp),pointer::prg%name="ocean_geothermal"g%doc="Geothermal bottom heat flux (bed-side analogue of the surface heat flux)."pl=>cfg%ocean%geothermal%enablecall g%add(nml_logical("enable",pl,&"Apply a constant geothermal bottom heat flux to the bed layer"))pr=>cfg%ocean%geothermal%q_geocall g%add(nml_real("q_geo",pr,&"Constant bottom heat flux (positive into the ocean from below)",&units="W/m^2"))call schema%add_group(g)end subroutine register_ocean_geothermal